Cart Contact

Axle Housing Configurator

Custom rear end housings built to your exact specifications. Width, bracket placement, tube size, and every detail tailored to your chassis and application.

Your Info

Contact Details

Step 01

Year, Make, Model & Body Style

Step 02

Chassis & Stance

Bracket placement, ride height, and suspension mounting points are determined by your chassis and stance.

Step 03

Housing Type

Select the center section and housing platform. This determines ring gear size, carrier type, and overall strength.

Ford 8.8"
Factory 9th gen F-150 rear end. 28 or 31 spline axles. Strong, common, well-supported aftermarket.
OEM
Ford 9"
Drop-out center section. Easy gear changes, legendary strength. The gold standard for custom builds.
Pro
Dana 60
Full-floating heavy duty housing. 35 spline axles, massive ring gear. Built for high-horsepower and off-road abuse.
HD
GM 14-Bolt
10.5" ring gear, full-floating. Factory 3/4 and 1-ton axle. Bulletproof for lifted and off-road applications.
HD
Step 04

Housing Width & Tube

Width is measured flange-to-flange. Custom widths allow you to run your desired wheel and tire combination with correct backspacing.

Step 05

Axle Shafts & Differential

Step 06

Wheel Mounting & Brakes

Step 07

Brackets & Tabs

Select the mounting provisions welded to the housing. These must match your suspension type and chassis.

Leaf Spring Perches
Welded spring perch pads at specified width and position. Standard for leaf spring suspensions.
4-Link / Ladder Bar Brackets
Lower 4-link or ladder bar mounting brackets welded to housing tubes. Positioned per chassis specs.
Upper Link / Coilover Mounts
Upper control arm or coilover mounting tabs on the housing center section or tubes.
Panhard Bar Mount
Welded panhard bar bracket for lateral axle location. Driver or passenger side.
Shock / Airbag Mounts
Shock absorber and/or airbag mounting tabs welded to housing tubes at specified location.
Traction Bar / Anti-Wrap Tabs
Mounting provisions for traction bars or anti-wrap devices. Common on high-power leaf spring setups.
Sway Bar End Link Tabs
Rear sway bar end link mounting tabs welded to housing tubes.
Brake Line Tabs
Hardline mounting tabs and flex hose brackets for clean brake line routing along the housing.
ABS Sensor Provisions
Machined or welded ABS sensor mounting boss on each axle tube end.
Diff Cover Stud Kit
Studs and hardware for differential cover. Allows easier service without removing the housing.
Step 08

Housing Finish

Submit your axle housing configuration and our team will provide a detailed quote including housing, internals, brackets, brakes, and all hardware.